Why does the footrest on the EZGO TXT Rear Flip Folding back seat for 1995 and UP not line up during installation?

Before continuing, please verify you have purchased the correct rear seat kit. You can call or message in with your serial number and we can verify that for you.

Some EZGO carts were manufactured without the holes in the plastic bag well. The holes do exist in the frame so you will only need to drill into the plastic.

If you look or feel under the back area. You will see two holes about an inch farther to the outside of each vertical support. Mark where these holes are on the plastic bag well for drilling. The vertical supports will line up perfectly to the footrest at this point.






Was this article helpful?
0 out of 1 found this helpful
Have more questions? Submit a request


Please sign in to leave a comment.